『Mortar flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
What are the grouting steps for self inserting anchor rods?
The grouting steps for self inserting anchor rods: ⑴ Check whether the grouting machine and its parts are complete and normal. ⑵ Check whether the particle size, ratio, temperature, etc. of cement and sand meet the regulations. Usually, a sieve is used to control their particle size. It is recommended that the particle size of sand be 1.0mm, and the ratio of cement to sand combustion should be from neat cement slurry to 1:1. ⑶ Use water or wind to check if the anchor hole is unobstructed, and return water or wind to the hole. Adjust the water flow meter to adjust the water cement ratio of the mortar to the measured value, and record the scale of the flow meter. The mortar coming out of the pump outlet must be uniform without any intermittent unevenness. Quickly connect the anchor rod, grouting pipe, and pump with quick couplings. ⑹ Start the pump to inject grout, and the entire process should be continuously injected without pause. It must be completed in one go. When the grout flows out from the edge of the grout stopper or the pressure reaches the design value, the pump can be stopped. If there is a blockage during the grouting process, the anchor rod, seepage dry slurry hose, and pump should be cleaned in a timely manner. At this time, if the pressure gauge of the pump shows that the reverse motor should be depressurized for 1-2 seconds, then each joint can be removed. The motor reverse time must be brief. After completing the grouting of one anchor rod, the joint between the grouting hose and the anchor rod should be quickly removed and installed on another anchor rod, and then grouting should be carried out; If the pump is stopped for a long tim
2. Application of Density Meter
Used for Density Timing: It can measure the specific gravity of various fluids, semi fluids, or mixtures.
. For example, random specific gravity in the processes of cement slurry, sand slurry, slurry, pulp, chemical products, and pharmaceutical products. Used for concentration timing: It can measure the percentage concentration (or ratio) of a solution or mixed buffer. For example, various concentrations of solutions, slurries, slurries, mortars, beverage flotation agents, etc. Combined with the analog flowmeter, it is easy to calculate the instantaneous mass flow rate and cumulative amount of dry minerals.3. Recently, I am looking to purchase electromagnetic flow meters because they are more accurate and cheaper. I would like to ask which company has a better quality ratio
Tianjin Xuner, electromagnetic flowmeter is cheaper, divided into intelligent electromagnetic flowmeter and plug-in electromagnetic flowmeter.. Intelligent electromagnetic flowmeter [applicable medium] Any conductive liquid [not applicable medium] Non conductive liquid, gas, steam negative pressure pipeline cannot be used [LDS product features] 1) Measurement is not affe
Hot Blog
Related AD
